Speed Limiter Removed ECU CFMoto UForce 600 EV (2025+)

replacement Bosch ME17 ECU
removal of legal speed limits of 60 km/h – 15kw
FOR OFF-ROAD / RACING USE only!
unrestricted speed – 85 (+/-5) km/h – 35kw
Plug and Play

This ECU is only for OFF-ROAD and/or RACING USE!

Availability : in stock

In stock (can be backordered)

Description

Speed Limiter Removed ECU CFMoto UForce 600 EV (2025+)

Easy to use replacement ECU (Engine Control Unit). Simply remove the standard ECU and connect the new ECU!
(Please refer to the manufacturer's installation instructions)

The Bosch ME17 replacement ECU without speed limiter is for OFFROAD and/or RACE USE only!

Engine control units (ECU, EPU…) are non-returnable. (Exception: Unopened, original packaging)

Manufacturer's speed rating: D gear 85 (+/-5) km/h, 35kw

WORKS WITH THE FOLLOWING MODELS
CFMoto UForce 600 EV, 2025-aktuell
UFU6EVMY25, UFORCE U6 EV L7e MY25 UP8 ECU
with Bosch ME17 ECU

INSTRUCTION

IB ECU CFMoto – speed limiter removed – Instruction from manufacturer

Make sure the vehicle ignition is turned OFF!
Disconnect battery negative terminal.
Locate the ECU and remove necessary screws to access the ECU.
Carefully disconnect the old ECU. Be careful not to damage contacts between ECU and connector.
Carefully connect new ECU. Be careful not to damage contacts between ECU and connector.
Reconnect the battery negative terminal.
Switch on the ignition and wait 60 seconds for the new ECU to communicate with the vehicle.
Start the engine and let it idle for 5 minutes to adapt to new values.
In some rare cases, fault code or engine light can occur. Usually, it is cleared after couple of engine starts and stops OR the fault code can be cleared with OBD diagnostic cable.

Reviews

There are no reviews yet.

Add a review Cancel reply

AnfrageRequest

Produktanfrage / Request to product: Speed Limiter Removed ECU CFMoto UForce 600 EV (2025+)

Datenschutz-Info akzeptiert * Datenschutz-Info gelesen und akzeptiert / I have read and accept the Data protection.