Wheel hub carrier steel Polaris

158,28  158,28 

The wheel carrier made of cast steel for the front axle for Polaris Scrambler / Sportsman 850/1000 is a good bet from the racing scene.

WORKS WITH THE FOLLOWING MODELS:
– Polaris Scrambler 850/1000 2013 –
– Polaris Sportsman 850/1000 2009 –

Availability : approx. 4 weeks

Out of stock

Share:

The wheel carrier made of cast steel for the front axle for Polaris Scrambler / Sportsman 850/1000 is a good bet from the racing scene. The original Polaris spare part is installed as standard on the rear axle. When used properly the original aluminum wheel carriers on the front axle often breaks and therefore the change to cast steel wheel carrier is a hot update.

In case of breaking of the standard aluminum wheel carrier it causes considerable damage to the brake system and to steering knuckles.

WORKS WITH THE FOLLOWING MODELS:
- Polaris Scrambler 850/1000 2013 –
- Polaris Sportsman 850/1000 2009 –

ASSEMBLY INSTRUCTION

WHEEL HUB CARRIER STEEL POLARIS SCRAMBLER / SPORTSMAN 850/1000

The update tot he cast steel wheel carrier is a good investment fort he discerning driver.

Proceed as follows:

1.      pick up your Polaris and secure it
2.      dismantle the wheel
3.      open the splint pin of the axle and remove it
4.      open the crown nut and remove the brake caliper (2x 15mm SW screws)

Then remove the wheel carrier, knock out the wheel bolt with a rubber hammer and remove the brake disk. Reassemble in the reverse order with the new wheel carrier.

Lubricate the bearing points of the wheel carrier with grease before installation.

TORQUE:
Brake Caliper Screws 50 NM (according to Polaris Loctite 243 Mid-Fescue Blue)
Crown nut 108 NM (do not forget the sapwood)
Wheel nuts102 NM (according to Polaris), recommendation Jay Parts not more than 85 NM.

We recommend to check the wheel bolts, brake pads, wheel bearings, ball joints, tie rod ends before the conversion, as it is optimal to change at the same time.

DOWNLOAD assembly instruction

Reviews

James

Thanks for the great solution 😉

Show reviews in all languages (1)

Add a review

Produktanfrage / Request to product: Wheel hub carrier steel Polaris

    Datenschutz-Info akzeptiert * Datenschutz-Info gelesen und akzeptiert / I have read and accept the Data protection.

    Please enter the result of the calculation into the captcha field./Bitte gib das Ergebnis der Berechnung in das Captcha-Feld ein.

    Info

    Manufacturer information

    MANUFACTURER
    JAY PARTS GmbH
    Lothringenstrasse 6/20, AT-4501 Neuhofen an der Krems, Austria
    info[at]jay-parts.com

    Item added to cart View Cart Checkout
    Item added to wishlist View Wishlist
    Item removed from wishlist