Vauhti Varikko Power ECU CFMoto CForce 1000 G3

INSTRUCTION

Vauhti Varikko Power ECU CFMoto CForce 1000 G3 – Instruction

1. Make sure the vehicle ignition is turned OFF!
2. Disconnect battery negative terminal.
3. Locate the ECU and remove necessary screws to access the ECU.
4. Carefully disconnect the old ECU. Be careful not to damage contacts between ECU and connector.
5. Carefully connect new Power ECU. Be careful not to damage contacts between ECU and connector.
6. Reconnect the battery negative terminal.
7. Switch on the ignition and wait 60 seconds for the new Power ECU to communicate with the vehicle.
8. Start the engine and let it idle for 5 minutes to adapt to new values.
9. In some rare cases, fault code or engine light can occur. Usually, it is cleared after couple of engine starts and stops OR the fault code can be cleared with OBD diagnostic cable.

Have fun with your new Power ECU!

Produktanfrage / Request to product: Power ECU CFMoto CForce 1000 Gen 3